The place to search for information about the Sachs 301 wheelhubengine as used on the
Spartamet ®, Saxonette ® and Rabbit ®.
Maintenance, revision and drawings.
Removal of the rear wheel. |
|
| First place the bike on his center-stand or place the bike on a pile of bricks in such a way that the bike is stable and the front wheel is free. | |
 |
Remove the endcap of the chain-guard. (There are diferent models in use buth no pictures available) |
 |
Place the contol-lever in the choke position. |
 |
Push the fuel-filter out of the clamps. Remove the protective cover from the carburettor. |
 |
Remove the fuel-line from the carburettor and place it on the plastic stand at the underside of the fuel-tank. In case of a fuel crane just close the crane. |
 |
Remove the choke and throttle cable from the levers. |
 |
Remove the red protection cap from the rear-brake lever and detach the cable. |
 |
Pull the cables out of the crank-case |
| In case of an E-start model unplug the connectors from the starter motor and ignition. | |
 |
Remove the starter rope stand from the holder. |
 |
Use two wrenches nr. 13 to losen the bolt from the exhaust and remove the bolt. |
 |
Losen the two capped wheelnuts with a wrench nr. 15. The wheel will go automatically downwards. |
 |
By lifting the rear end of the bike you will get room to remove the chain from the sprocket wheel. |
 |
By lifting the rear end further you will get room to remove the rear wheel from the bike. |
Now you can easely replace the tire or remove the engine from the wheel for revision. |
|
Visitors online:
Last update: 16-06-2008
© Sekeris Supply & Support
